Results 1 to 2 of 2
  1. 06-04-2005, 10:42 AM #1
    jtalbert
    jtalbert is offline Regular Guest
    Join Date
    May 2005
    Location
    TN
    Posts
    8
    In section 11-12 of the manual D, it explanins the use of a Sensible load correction factor (SLCF) to determine peak loads associated for duct runout calculations. I am using the HVAC -Calc program and am wondering if the program takes into account these SLCF's when it computes the heating and cooling loads?

    The Manual D sure is a bundle of fun to read!

    Thank you for any clarification.
    Reply With Quote Reply With Quote
  2. 06-04-2005, 10:44 AM #2
    Mr Bill's Avatar
    Mr Bill
    Mr Bill is offline Professional Member*
    Join Date
    Dec 2002
    Location
    Houston,Tx.
    Posts
    14,910
    Originally posted by jtalbert
    The Manual D sure is a bundle of fun to read!

    Hey they also have the Jose D but it's written in spanish.
    “I am glad that I paid so little attention to good advice; had I abided by it I might have been saved from some of my most valuable mistakes.” - Edna St. Vincent Millay

    The critic is a prisoner to his own experiences and perspectives, erroneously believing his limited experiences are the sum of all truth.

    No Guns…No Freedom…Know Guns…Know Freedom.




    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules