LCD Temp and Humidity Stat
Does anyone have any suggestions on a LCD temperature and humidity stat.
We are looking for one which can show these temps on the LCD display.
The output from the temperature and humidity needs to go into a controller via a 4-20ma or 0-10 signal.
And last also provide a setpoint from the stat for temperature.
Do you need both on the display?
ACI - www.workaci.com has some but I don't think they will display both F & RH on the lcd.
I was used ones from Veris before. I think BAPI also make one.
"Open is as open does."
- Forrest Gump
"Can't we all just get a Lon?"
- Garry Jack
"BACnet: integration or interrogation?"
- The Janitor
"Open protocols? You can't handle open protocols!"
- Nathan R. Jessup
“What’s that? Aaa… open protocols? Don’t talk about…. open protocols? Are you kidding me? Open protocols? I just hope we can hardwire an interface!”
- Jim Mora http://www.youtube.com/watch?v=U7fjDS0jKiE
I just went through a similar situation. I needed to control a proportional reheat valve 0-10 vdc signal. Display temp and RH%, and provide the info on the BACnet network. I didn't want a central controller, wiring runs are hundreds a feet apart. I found a Viconics device that should do the trick. the problem is the device also has fan speed keys. I talked to Viconics and they said I can purchase a stat cover to hide the keys. I think Veris may sell the same with a different part#.
Silk spyder with Zio module. You can write to the LCD of the Zio module (8 characters).