Page 2 of 2 FirstFirst 12
Results 14 to 15 of 15
  1. #14
    Join Date
    Jun 2004
    Location
    Florida
    Posts
    556
    I read the report and from what I understand at 95 degrees the capacity is about the same, but at 130 degrees the 410A had a 9% reduction in capacity. As far as efficiency the 410A was 4% lower at 95 degrees and 15% lower at 130 degrees. I'm in Florida and we might see a few hours a year at 105, but I've never seen it hit 130.

    Out of the units they tested the r-22 unit had a 12.5 seer and the 410A unit had a 13 seer. 410A does appear to loose it's efficiency faster as the O/A temp rises, but it looks like at approx. 90 degrees they are the same and below 90 degrees the 410a unit is slightly more efficient. I think it is a wash, and the decision to go with one refrigerant over the other should be based on something other than efficiency.

    I looked up the refrigerant weight of those two units and the 38YRA036 (R-22)has a charge of 7.13 Lb. @/15' and the 38YZA (410A) has a charge of 8.375 @15'. It looks like you actually need more Puron than R-22.




  2. #15
    Join Date
    Aug 2002
    Location
    Office and warehouse in both Crystal River & New Port Richey ,FL
    Posts
    18,836
    The fact is no manufacturers have redesigned coils,for Puron/R410a ,so that could have a lot to do with todays performance.

    Carrier will have dedisgned for Puron,from the ground up ,starting with 2006, 13 SEER minimum mandate.It will be interesting to se what that brings.

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event