Castile Pellet stove

[mtnjack]

I have recently replaced the exaust blower motor on my pellet stove. Went through and cleaned it completely. The problem is the blower motor runs non stop where do I go from here?

[jtp10181]

Wait 20 minutes, it will stop. This is quite a common question on here. After power is "restored" the comb blower runs for 15-20 mins to clear any smoke that may have been in the firebox from a power loss while it was burning.

[mtnjack]

It used to shut off after 20 or 30 min thats what Im used to. It doesnt shut off unless I unplug the unit at this time it has been running without any fire or coals for7 hrs and it will continue to run unless I unplug the unit. What do I check next as soon as I plug it back in it will continue to run weather it is calling for heat or not.

[jtp10181]

The control box is what makes it go, you must have fried the control box when replacing the motor. Expensive mistake.

[mtnjack]

Themocouple lights work, feeds, and stops feeding when reaches set temp only problem exaust blower wont shut off. UNit was unplugged when being worked on cant think of how i fried it but always a possability. thanks for suggestions if you can think on anything else willing to try.