Results 1 to 4 of 4
Thread: Airco Saver
-
02-04-2011, 10:46 AM #1
New Guest
- Join Date
- Feb 2011
- Location
- Knoxville, TN
- Posts
- 1
Airco Saver
Anyone have any experience good or bad with a product called the AircoSaver? The theory of operation is: the device has a sensor-driven software algorithm that detects thermodynamic saturation of coils to switch the compressor off while fan still runs to maximize stored cooling capacity; once coils temperature rises (after short-cycle prevention time expires); compressor kicks back in. Touted as a potential 20-30% energy saving device for air conditioning.
-
02-04-2011, 10:52 AM #2
Professional Member*
- Join Date
- Feb 2010
- Location
- In a boiler room
- Posts
- 6,417
Hi and welcome.
What happens on design days when you need full capacity to keep up with the load?
Do you need to add a hard start kit?
-
02-04-2011, 11:57 AM #3
ARP Committee & Global Moderator
- Join Date
- Jan 2006
- Location
- Near Atlanta, GA.
- Posts
- 14,055
Welcome to HVAC-Talk
As stated in the header, this forum is primarily a welcome area and not for asking technical questions. Your question would be better posed in the Residential HVAC forum down the page a bit in The Arpa Zone section.
-
02-04-2011, 11:58 AM #4
Professional Member
- Join Date
- Nov 2010
- Location
- Andover Kansas
- Posts
- 2,115
Welcome to the site.
.
The statement below is my signature and just my overall feeling towards our industry and does not necessarily pertain to you nor this thread.
There really isn't a legitimate excuse for not doing the job correctly!
Reply With Quote
