I’m going to have central air installed in my home and I have a few questions.
First, and probably the most important how do I find a quality contractor?
Second, I have 100 amp service in my home with no major electrical appliances (no electric stove, water heater, dryer etc.) and would like an opinion on if I can use the existing service for the new air conditioner? I have a 1500 sq ft ranch in Northern NJ with high quality windows and average insulation so I’m guessing I will need at most a 3 ton unit, what is the electrical requirements for a unit of this size? I know the contractor will spec out the real #s but I'm hoping for an educated guess if I will need to budget for an electric upgrade as part of the installation. I have a 220v 10-3 electric line that was used by a previous owner for an electric dryer available for the compressor unit if this is sufficient.
After reading a good number of posts here I am leaning toward the Carrier Infinity as a top choice unit. I have high humidity in my area and the Infinity looks like a good performer for humidity control. Does going with a Carrier “factory authorized dealer” give me a better quality installer? Thanks in advance for your help.
I assume you have hot water or steam heat. and the AC system will be separate with new ductwork. I am in New Jersey and a Trane Dealer. Carrier, is a good piece of equipment, so is Lennox and so is Trane. You need a good installer.
Most 3 ton a/c units require a 30 amp service . 1 or two may require 35 amp maximum breaker but a lesser ampacity. Either way 10/3 gage wire is sutible.
Carrier Authorized Dealer Info (place in bottom left to enter your zip code to locate someone in your area)
More info on Infinity
Trane Residential (be sure to check out the Trane System customizer)
Locate a Trane Dealer (Look for a Trane Comfort Specialist)
Extend to others the grace that God has given you.