Results 1 to 5 of 5
  1. #1
    Join Date
    Feb 2005
    I have a Lennox Innovator furnace that is not firing and I am looking for suggestions as to how to remedy the problem? The pilot is lit, and it sounds like the furnace tries to kick on but it never does. Any suggestions on what I should do?

    If it is a matter of cleaning a sensor, do I need a licensed serviceman to do this or is it simple enough that I could do it.

  2. #2
    Join Date
    Nov 2001
    I'm not sure what model that was,
    But it sounds like you should make a call.
    If you try to fail, and succeed.
    Which have you done ?

  3. #3
    Join Date
    Jul 2002
    St Paul, Minnesota
    A sensor senses something (flame) and if no flame it can not do it's job. Read the manual if you have one, when you get to the part about calling a service technician, pick up the phone and make the call. You are in over your head.

  4. #4
    Join Date
    Mar 2002
    Richmond, Virginia
    Innovator covered a large line of equipment. Innovator was changed to "Signature Series". It denotes top of the line equipment. I doubt very seriously there is a pilot in that furnace. Model number is the only way to identify it. Sounds like it's time to make that call.
    There is nothing more frightful than ignorance in action....Mark Twain

  5. #5
    Join Date
    Dec 2004
    Turn on the gas valve

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365