metro detroit

[klyons20]

Do any one know of any sheetmetal fabrication shops in the detroit area.

regards,
Kelvin

[Edited by klyons20 on 02-17-2005 at 06:21 AM]

[Chuck 999]

I think,what you mean is that does anyone in the metro Detroit area know of any sheetmetal fabrication shops.You should read what you post because you sound like an illiterate! I am 20 miles outside of Detroit.


Chris

[coolwhip]

Capitol sheet metal on rochester road south of 14 mile on the west side. Ask for Doug.

[Hroper]

cedermechanical
Member

Registered: May 2003
Posts: 18
Im in the market for a new software program that I mostly want for proposals.Im looking at the Elite Software and the Wrightsoft program and I was wondering before I bought either if anyone has had success with any of them and if so what were the pro's and con's of the one's you used, any input would be great!

Chris

[johnl45]

Originally posted by Hroper
cedermechanical
Member

Registered: May 2003
Posts: 18
Im in the market for a new software program that I mostly want for proposals.Im looking at the Elite Software and the Wrightsoft program and I was wondering before I bought either if anyone has had success with any of them and if so what were the pro's and con's of the one's you used, any input would be great!

Chris

I'm using Wrightsoft residential suit with WrightDraw and WrightD I love it even thou it's a little pricey. Download a fully fictional version at www.wrightsoft.com/

[Edited by johnl45 on 02-17-2005 at 12:00 PM]