Hey guys I'm posting a few questions that I am not sure what the answers are. Let me know what you guys think, as many responses as possible would be greatly appreciated
#1 The heat loop in a heat pump is connected to?
A. Evap + cond.
#2 With a 3 Phase 440Volt 4 Wire Power supply, How would you change the Rotation of a 115 VOLT Compressor?
A. Switch 2 Service lines
B. Switch 2 Compressor leads
C. Switch Windings in comp.
D. Switch Block leads in electrical Head.
#3 On a Hermetic Comp. the vibration absorber is?
A. Perpendicular to the crankshaft and clamped at the comp.
B. Parallel to the crankshaft and clamped at the opposite end.
C. Parallel to the crankshaft and clamped at the opposite end.
D. Pependicular to the crankshaft and clamped at the opposite end.
#4 If a sensor bulb was not working properly and would need to be replaced by?
A. Electronic bulb
B. Averaging bulb
#5 As the suction pressure increased the Averaged oil pressure would?
C. Stay Approx the same