Page 1 of 2 12 LastLast
Results 1 to 13 of 26
  1. 10-06-2004, 11:42 AM #1
    Reliant Air
    Reliant Air is offline Professional Member
    Join Date
    Jun 2004
    Location
    Florida
    Posts
    556
    Post Likes
    What do you guys suggest for the equipment? I have a project that has a 180 sqft pool in a 400 sqft room with 18ft ceilings and a lot of glass. The supplier I talked to wanted to use a water source system and I would have to have some sort of cooling tower outside. I would prefer a dx system.
    Reply With Quote Reply With Quote
  2. 10-06-2004, 11:54 AM #2
    Boiling Point
    Boiling Point is offline Regular Guest
    Join Date
    Aug 2002
    Posts
    718
    Post Likes
    Check out the Dectron site - the best in my opinion. They have DX units that will pump the pool water as to a heat exchanger in the unit for a condenser and as it reaches above its ability will kick on the air cooled condenser. They have different configurations as well.
    Reply With Quote Reply With Quote
  3. 10-06-2004, 05:22 PM #3
    Green Mountain's Avatar
    Green Mountain
    Green Mountain is offline Professional Member
    Join Date
    May 2001
    Location
    Bennington, Vermont U.S.A.
    Posts
    13,856
    Post Likes
    Originally posted by dhanna
    What do you guys suggest for the equipment? I have a project that has a 180 sqft pool in a 400 sqft room with 18ft ceilings and a lot of glass. The supplier I talked to wanted to use a water source system and I would have to have some sort of cooling tower outside. I would prefer a dx system.
    When ever I get this type of request I contact DessertAire.
    You fax them a sketch of the room and they will spec the equipment for you. They are god-awful expensive.(cupoura(sp)nichol construction.) Most indoor pool owners are cheap. (can't we dehumidify my $60K pool with a window AC?)
    So I usually don't get the job. Saints be praised!!
    ESSAYONS

    www.ductstrap.com
    Reply With Quote Reply With Quote
  4. 10-06-2004, 06:38 PM #4
    slimwoodie
    slimwoodie is offline Banned
    Join Date
    Dec 2001
    Location
    Southern Tier, NY
    Posts
    6,066
    Post Likes

    ever hear ...

    of PoolPack ?? that's all they do ....
    Reply With Quote Reply With Quote
  5. 10-06-2004, 08:32 PM #5
    DeltaT's Avatar
    DeltaT
    DeltaT is offline Professional Member*
    Join Date
    Nov 2001
    Location
    Seattle, WA
    Posts
    8,003
    Post Likes
    Also try http://www.aeretech.com/
    "The American Republic will endure until the day Congress discovers it can bribe the public with the public's own money.
    - Alexis de Toqueville, 1835
    Reply With Quote Reply With Quote
  6. 10-06-2004, 08:42 PM #6
    service guy
    service guy is offline Regular Guest
    Join Date
    Feb 2004
    Posts
    534
    Post Likes
    Originally posted by benncool
    Originally posted by dhanna
    What do you guys suggest for the equipment? I have a project that has a 180 sqft pool in a 400 sqft room with 18ft ceilings and a lot of glass. The supplier I talked to wanted to use a water source system and I would have to have some sort of cooling tower outside. I would prefer a dx system.
    When ever I get this type of request I contact DessertAire.
    You fax them a sketch of the room and they will spec the equipment for you. They are god-awful expensive.(cupoura(sp)nichol construction.) Most indoor pool owners are cheap. (can't we dehumidify my $60K pool with a window AC?)
    So I usually don't get the job. Saints be praised!!
    Ditto I have had alot of success with them
    Reply With Quote Reply With Quote
  7. 10-06-2004, 11:02 PM #7
    karsthuntr's Avatar
    karsthuntr
    karsthuntr is offline Professional Member*
    Join Date
    Mar 2004
    Location
    Grottoes VA
    Posts
    5,854
    Post Likes
    I've installed about 15 Desert-Aire units and have had very good luck. Pool-Pak (I've installed 2) suck, IMO.
    Karst means cave. So, I search for caves.
    Reply With Quote Reply With Quote
  8. 10-07-2004, 10:31 AM #8
    Reliant Air
    Reliant Air is offline Professional Member
    Join Date
    Jun 2004
    Location
    Florida
    Posts
    556
    Post Likes
    Thread Starter
    Desert Air was the first place I started to look, but the owner told us not to waste our time. I didn't ask why. It sounded like they had a bad experience. I like the Dectron unit. I want one that will do the cooling and heating too.
    Reply With Quote Reply With Quote
  9. 10-07-2004, 10:48 AM #9
    Boiling Point
    Boiling Point is offline Regular Guest
    Join Date
    Aug 2002
    Posts
    718
    Post Likes
    Like i said - we maintain a lot of the YMCA's in the area and a few schools and Dectron is the way to go as far as I am concerned. Fantastic tech support is another area they excell in.
    Reply With Quote Reply With Quote
  10. 10-07-2004, 11:10 AM #10
    teddy bear's Avatar
    teddy bear
    teddy bear is offline Sponsor & Professional Member*
    Join Date
    Jun 2003
    Location
    Madison, WI/Cape Coral, FL
    Posts
    8,354
    Post Likes
    Originally posted by dhanna
    What do you guys suggest for the equipment? I have a project that has a 180 sqft pool in a 400 sqft room with 18ft ceilings and a lot of glass. The supplier I talked to wanted to use a water source system and I would have to have some sort of cooling tower outside. I would prefer a dx system.
    All of the mentioned brands are very expensive and have high operating cost. There is new, smaller, more efficeint equipment available. 180 sq.ft. of water requires 4 lbs. of dehumidification per hour. Check out the Therma-Stor line. They are half the cost twice the moisture removal per kwh. Covering the pool when not in use further reduces the amount of dehumidification needed. This is their top line unit. for 450 sq.ft. of water.
    http://www.thermastor.com/DesktopDefault.aspx?tabid=301
    Reply With Quote Reply With Quote
  11. 10-07-2004, 11:20 AM #11
    ozone drone
    ozone drone is offline Professional Member
    Join Date
    Aug 2003
    Location
    Ft Worth Tx ( North Richland Hills)
    Posts
    2,143
    Post Likes
    Dectron
    How can you have any pudding if you don't eat your meat?
    Reply With Quote Reply With Quote
  12. 10-07-2004, 11:24 AM #12
    Boiling Point
    Boiling Point is offline Regular Guest
    Join Date
    Aug 2002
    Posts
    718
    Post Likes
    [QUOTE]Originally posted by teddy bear
    [B]
    Originally posted by dhanna
    All of the mentioned brands are very expensive and have high operating cost. There is new, smaller, more efficeint equipment available.
    Hoe do you figure that??
    Reply With Quote Reply With Quote
  13. 10-07-2004, 11:25 AM #13
    Boiling Point
    Boiling Point is offline Regular Guest
    Join Date
    Aug 2002
    Posts
    718
    Post Likes
    [QUOTE]Originally posted by teddy bear
    [B]
    Originally posted by dhanna
    All of the mentioned brands are very expensive and have high operating cost. There is new, smaller, more efficeint equipment available.
    Hoe do you figure that?? Do you factor in life span??
    Reply With Quote Reply With Quote
Page 1 of 2 12 LastLast
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules
Contracting Business

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
HPAC Engineering