turbocor not loading - Page 3
Page 3 of 3 FirstFirst 123
Results 27 to 29 of 29
  1. #27
    Join Date
    Feb 2010
    Posts
    81
    Quote Originally Posted by 19C View Post
    Thanks D man for the feed back. I had problems with 3- gen 1 suctions covers over the years,end up changing to gen-2 covers. Really like the gen-2 covers easyer to change suction temp/pressure transducer. Thank's again.
    Missing screw from igv asembly????

  2. #28
    Join Date
    Feb 2010
    Posts
    81
    Quote Originally Posted by directman View Post
    Have had issues with the IGV assemblies where the set screw has come out from the stepper motor causing it to spin in the housing and pinching the wires to the housing. Wires shorted and took out the mini inboard fuses on the backplane. Had to replace the backplane board. Have you ohmed out the stepper motor windings on the pins on top of the IGV assembly?
    Right on

  3. #29
    Join Date
    Dec 2007
    Location
    Northern California
    Posts
    32
    Quote Originally Posted by rover View Post
    Missing screw from igv asembly????
    Mr. Rover All of them, the stepper motors where loose and would bind up anywhere from
    0 to100%. I guess I'm not the only one to see this. Have a good one.

Page 3 of 3 FirstFirst 123

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event