Damn GregF!! It took me longer than that to read the directions.
Funny story, Tridium messed up the PO and when I got there (in LA) we had to figure out what happened. It was after lunch before I got into class and I was number 13. They only do 12 so I had no controls to work with. The next day I brought in my own and away I went. I gave Gerard a boolean to enum block and it helped. The only reason he graded me in class was because it was my equipment, no back up. By the way every body builds the test the afternoon be fore.
That sounds like a much different situation than what we had. Before Friday there was no hint of what was on the test. I think there was something like 12 pages of instructions.
I agree with the statement about being sure to do the CBT before going. That really made a big difference for me.
Unless you have a decent amount of control experience I would say that starting with Tridium might be like learning how to swim by 'jumping into the deep end of the pool'. Almost everything on the test is covered in the class so if you can keep pace with the class the test should be manageable.
Thanks for the info but as far as controls i know very little.
I have a Associate degree in HVACR and have been in the hvacr industry` for ten years but have only been around controls at our schools for 15 months and i didn't know where to start so this is why i ask you guys... Thanks again
The only dumb question is the one you don't ask.
Everyone starts out not knowing everything so when in doubt ask.
Even i still ask questions.
I currently work for a local school and need to learn more about ddc controls and software but i'm very green so i hope i am not jumping in to deep to get started. I currently have honeywell controllers(W7750 C2001controllers)
and UNC410-1 front ends on a lon network but have been doing alot of studing of articles found on the internet.....