Page 2 of 2 FirstFirst 12
Results 14 to 17 of 17
  1. #14
    Join Date
    Oct 2008
    Posts
    784
    Quote Originally Posted by RuudInstaller View Post
    Or if they rip the wire off of the drain switch, gas valve, or flame sensor while trying to open the drain valve, I have seen this many times.
    Or a wire going to the blower motor"s stator winding, which they told me...uh "We tried to stick it back in but it didn't work."


    "You never know what others don't know." -

    If I can't laugh at myself...then I'll laugh at YOU! -

  2. #15
    Join Date
    Feb 2011
    Posts
    18
    Frymaster also has leds on the interface boards that can help in troubleshooting. Diagnosis can be made quickly.

  3. #16
    I would say either one of the flame sensors or one of the ignition modules. I would start with 2 flame new sensors. I don't think it is a computer problem, usually when a computer goes bad and says help it doesn't happen intermittently.

  4. #17
    Join Date
    Feb 2011
    Posts
    18
    The leds on the board can also be used to troubleshoot the appliance.

    Regards Ian

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event