Results 1 to 3 of 3
  1. #1
    Join Date
    Jun 2004

    Staefa Smart Controller help

    I am replacing some SM2 Smart Controller 2 boards, can you hook into these to see points? I see a connection port on the front, do they require specific software or can hyper terminal be used?

    It does have a front end computer hooked up but seems to have limited access in that also. MS-1800 system, graphical only and does not show actual hardwired point locations.

    Any help would be appreciated. I just need to see what points are wired and if they have names associated with them. ie IN4 = Supply Temp, DO1 = Supply Fan, etc...


  2. #2
    Join Date
    Dec 2008
    Gainesville, FL
    You need the hand tool or a copy of pc-tool which is much better to run on a lap top. Pm me

  3. #3
    Join Date
    Jun 2004
    Can't PM you, my email is in my profile could you send it to that? Thanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event