I am not sure what the tool kit software is called. My 50 ton came with no software. I had to read that book and push buttons for 12 hours to get up and running. Then I find out they sell a tool kit ( software and cable for lappy ) . I did ask Carrier about a interface and it took 2 weeks for them to get back to me. By that time I had it up and in service.
I was just wondering if there is anything ( like start delays times ) I could tweek if I had the software.
Na it came with the computer. Some one swiped the palm pilot and cable before I got it off the truck! I am looking to change time delays on compressor off cycles. it is touch and go as far as getting compressors online in time to hold set point. I was hoping to be able to change the time delays with the palm pilot or a disk and a lappy. Either way, I am ok with buttons and scrolling but I was hoping to be able to get deeper in the program.
I found out a few days ago the customer is wery wery weerrrry close to chapter 11 so I am not worried anymore. But..... there is always the next one to work one!
Hi Jason, Enquiring about the Carrier service tool. I have tried to purchase it here in Australia, Melbourne, with no luck. Carrier say it's in house only and don't sell it outside the company. Do you know where i would be able to purchase the software from? I already have the converter, which I believe is required for the old Carrier models as well, the Flowtronic. Your advice would be greatly appreciated. Cheers.
Hi, Wondering where I can purchase the Carrier navigator from and approx how much it would be? Unable to get my hands on any Carrier software or navigator in Australia, Melbourne. They don't like to help you out over here!! Does the navigator have all the same software as the software program used through a lap top? Thanks for all your help, would be greatly appreciated.