The mz controllers is programmed through the software "XPSI"..there are different versions if u r going through windows xp and windows 98.I have both if u need any I will send u..another important thing is network controller like my self is working on invensys UNC and the old one LNC and GCM..we have a almost 12 years old site in which GCM installed with mz and MNflo2 controllers for vav..there are different ways while connecting through UNC and GCM/LNC...U can also connect MZ directly from ur serial port connecting through a device called ATARI...do confrim the device name because I have never connected directly but u can connect directly as well...
Originally Posted by Control Loopy
Could you please copy me in with any information on these units - I have two of these controllers which I have searched the world for data, connection information and software for.
I know they are old but I think Invensys (?) still make them in one form or another, and one manufacturer has made an adaptor card to update/retrofit them - so they must be reliable and widespread.
The mz controllers is programmed through the software "XPSI"..there are different versions if u r going through windows xp and windows 98.I have both if u need any I will send u..
Thanks for information - I have got an XP and 98 laptops both with serial ports, so either or both versions would be great.
Have you got any details on the connection lead(s) or software configuration?
I have found a datasheet with the Atari Portfolio device shown - I haven't got one, but if needs be I could probably get one if this is the easier route?
Please let me know, email in profile - Many, many thanks!
I hve never connected from ATTARi...but while connecting through GCM the connection type is GCM RS232,baud rate is 9600,The com port can be 1 or 2...I think while connecting directly the connection type might be PSI host and the rest of them should be the same...need to go through the literature for this...tell me about the UNC type u r using...