Results 1 to 2 of 2
  1. #1
    Join Date
    May 2002
    Posts
    2

    Blower Wheel Alignment

    I'm replacing the blower motor in an American Standard upflow furnace and I noticed the blower wheel was not exactly centered in the blower chamber. It was about a 3/8 inch closer to the inlet opposite the motor. This was the factory motor and I could tell from the set screw marks that the wheel had never been repositioned. I'm planning to put it back together with the wheel centered unless there is some compelling reason for having offset a little. Am I overlooking something here?

  2. #2
    Join Date
    Jan 2004
    Location
    PA
    Posts
    68,770
    Sorry, this is not a DIY site.

    Thread closed.
    Contractor locator map

    How-to-apply-for-Professional

    How many times must one fix something before it is fixed?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event