Roof job finally done.. warning I posted a book

[Lash]

I hired the Draftsman that drew the plans, I hired the P.E. that sealed the plans, I pulled the permits for the job, I hired the Welder that installed the the angle, I cut the hole in the roof, I bought the curbs, I mounted the curbs, I hired the roofer, I hired the crane operator, i bought the RTU, I installed the RTU, I hired the electrician to wire it, I ran the low voltage, I installed the thermostat, my guys did the majority of ductwork, I did some of it, This is my work.

You are God.

[Lash]

as plans sealed by a Registered Engineer or an Architect are required for a Permit for any structural work.

Really?????




/sarcasm

[bwalley]

You are God.

I am not God.

[Lash]

It is amazing how you "Professionals" defend work like praha did in this post, here he mounted disconnects to service panels, condensors are too close, had sloppy unsupported service lines, he said permits or a license, or even inspections are not required, I seriously doubt an Engineer or any other professional was involved with this job.

I really don't tink anybody is interested in paraha's install anymore. I think most of the attention has been drawn to you way up on your horse. whistle1

[jrbenny]

The unprofessional behavior in this thread is absolutely appalling. Each of you should be embarrassed with your individual behavior. You drag this industry to new lows with this kind of rubbish.