Page 12 of 12 FirstFirst ... 256789101112
Results 144 to 150 of 150

Thread: i Manifold

  1. #144
    Join Date
    May 2006
    Location
    Deep Southeast
    Posts
    4,282
    Post Likes
    I guess the impossible is possible when it's expedient. Nicely done.

  2. #145
    Join Date
    Dec 2012
    Location
    columbus, OH
    Posts
    4,719
    Post Likes
    Quote Originally Posted by itsiceman View Post
    That was kinda cheating
    I do this alot on coolers and freezers. Usually tighter and harder to get at all blind (colder too lol).

    That was nearly pornographic. :-)

    I should do one of me insulating a sensing bulb on a trane coil with rick james playing

    Sent from my SM-S320VL using Tapatalk

  3. #146
    Join Date
    Jan 2017
    Location
    Phoenix AZ
    Posts
    46
    Post Likes
    Quote Originally Posted by vin lashon View Post
    I'm not sure the tesp is supposed to effect/change the airflow, since iManifokd would have to have the blower performance charts for that specific unit. You could check those charts and enter the cfm manually based on tesp.

    BTW, I have both the clamps and the straps, but prefer the straps, since I can leave them on the probe along with the hoses. Just makes for quicker & simpler usage IMO.

    One clamp I use for discharge line temp, the other I sometimes use for suction or liq libe line temp at evap.
    Vin you are correct. The TESP is just a measurement until you compare it with the blower performance data from the unit you are working on. The blower performance data graph will show CFM the system will produce at measured TESP. Specific blower performance data is available from the manufacturer of the unit.

  4. #147
    Join Date
    May 2006
    Location
    Deep Southeast
    Posts
    4,282
    Post Likes
    Question: What does iManifold do with the DLT? Is it just information, or does it pertain to other calculations within the app?

  5. #148
    Join Date
    Mar 2007
    Location
    Connecticut
    Posts
    115
    Post Likes
    Quote Originally Posted by vin lashon View Post
    Question: What does iManifold do with the DLT? Is it just information, or does it pertain to other calculations within the app?
    Hi Vin,

    The iManifold app uses DLT for troubleshooting and heat pump functionality. If you do not measure or supply the DLT(s) for AC mode, it will not affect anything from what I can see in the code.

    Buck

  6. #149
    Join Date
    Jan 2010
    Posts
    276
    Post Likes
    Buck when is the app going to function properly . And for the 900th time when will we be able to calculate multiple superheats off one low pressure probe .and reports for refrigeration would be nice .

  7. #150
    Join Date
    Mar 2007
    Location
    In the Conservatory with a Lead Pipe
    Posts
    14,218
    Post Likes
    Quote Originally Posted by kevincompass View Post
    Buck when is the app going to function properly . And for the 900th time when will we be able to calculate multiple superheats off one low pressure probe .and reports for refrigeration would be nice .
    Seems like low priority bud.

Page 12 of 12 FirstFirst ... 256789101112

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.