Mastercool
Results 1 to 2 of 2

Thread: Mastercool

  1. #1
    Join Date
    Feb 2008
    Location
    Vancouver, BC
    Posts
    41

    Mastercool

    I'm just wondering if anybody else finds that the Mastercool ball bearing pipe cutter leaves a lip on the outside edge of the pipe?

    It's gets annoying when I cut down 1 1/8 and 1 3/8 pipe and I have to get the file out to file down the damn lip so I can put my fittings over the end.

    I bought a new cutter wheel and even returned my first cutter back to the supplier. I'm just seeing if it's just me or a design flaw with these cutters.

  2. #2
    Join Date
    Jul 2008
    Location
    Nova-Scotia, Canada
    Posts
    271
    Yes!

    I did a lot of supermarket reno's in the past six months. Trying to get fitting on the damn pipe is a nightmare. They work well except for that outer burr. It's a pain to try and get off even with a deburring tool give you're on the outside of the pipe.

    Went back to Imperial and am happy thus far.

    As of now I work with ridgid imps, Imperial up to 1 1/8, 1 5/8 and the gigantic ones

    I've found the yellow jacket cutters bum out over time and draw designs in your pipe.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event