Barber Colman GCM and LCM

**wmd** · 01-13-2009, 09:56 AM

I am in need of a GCM-84211-1 I have found a site with one used module but would like one that is new or repaired. Could someone point me in the right direction toward other surplus suppliers? Also I need the default keypad access for an LCM for this sytem. I am no longer a field tech but, I'm quite sure it is the factory default because I have accessed them before a few years ago and I know I wrote it down somewhere!! but have grown OLD and forgetful.
Any Help would be greatly appreciated.

**theoldman** · 01-13-2009, 03:47 PM

Press the "up" arrow then the "right" arrow then "enter". You can mostly only view with that logon. If you can use xpsi or hyperterminal into the LCM, you can edit the user properties to allow full access from the keypad. I will post how to do that when I remember how.

**wmd** · 01-13-2009, 04:02 PM

Thanks Much.
I thought for sure that I've accessed it before and as a superuser and made changes through the keypad using the + and - for setpoint changes and such on the loops but, the old grey matter is burning out so I could be mistaken?

**mikesands** · 01-13-2009, 05:49 PM

Should be able to get the parts form the local Invensys dealer. They should also be able to tell you how to access that thing.

**wmd** · 01-14-2009, 08:02 AM

Thanks Mike, I have purchased a GCM. I have covered every path I know at this point other than contacting a TAC dealer but, I'm fairly sure I'll not be able to get any tech assistance from a factory office.

**Control Man** · 01-14-2009, 08:39 AM

Get in touch with
www.abcontrolsusa.com

**wmd** · 01-14-2009, 04:21 PM

Control Man: I've bought the GCM from abcontrols. They couldn't help me with LCM superuser keypad code

**wmd** · 01-14-2009, 04:27 PM

Mike: Thanks Again, I'll give them a try

**mikesands** · 01-14-2009, 04:21 PM

Originally Posted by wmd

Thanks Mike, I have purchased a GCM. I have covered every path I know at this point other than contacting a TAC dealer but, I'm fairly sure I'll not be able to get any tech assistance from a factory office.

They would probably help you, gave that same advice to someone else here and they called the factory and got a default password. its up to you, its your time.

**Snides** · 01-14-2009, 08:10 PM

wmd.

Check your messages. User name and Password detailed.

**wmd** · 01-16-2009, 09:00 AM

Snides: check your messages. I'm new to the forum and not sure if I posted my reply to your message correctly.

**Snides** · 01-19-2009, 07:26 PM

wmd

Check your messages again.

**brdman** · 01-23-2009, 11:16 PM

Snides, is oz the name of your work?

Thread: Barber Colman GCM and LCM

Thread Tools

Search Thread

Display

Hybrid View