Did you get into the installers set-up menu and enable the remote sensor? I'm not sure if it's required on the T7300 but I believe that's the case.
I have a T7300 with a Q7300 subbase attached to a Jace.. This stat has a remote sensor attached and ever since it has been attached to the Jace it shows a room temp of 32 deg F. I have been looking to a NCI or a NVI that would tell it to look for the sensor but to no avail anyone have any suggestions????
Did you get into the installers set-up menu and enable the remote sensor? I'm not sure if it's required on the T7300 but I believe that's the case.
RealEyes
Realize
RealLies!