Results 1 to 2 of 2

Hybrid View

  1. #1
    Join Date
    Feb 2008
    Posts
    10

    Vykon Jace200 and Honeywell XL15C

    I was wondering if anyone else had a similar problem!
    I can't get and point values from the XL15C, I discovered all the points but all I get is nan (not a number) on my analog inputs ? All I have on the network currently is 2 XL15C and an Xl10 R/T controller. I seem to getting point info fine from the XL10.
    Any advice ALWAYS greatly appreciated!
    Thanks
    Jeff

  2. #2
    Join Date
    Aug 2007
    Location
    Western Colorado
    Posts
    497

    xl-15c

    Have you tried re-writing your xl-15c program using the workbenchs' wire sheet? That's what I ended up doing with my xl-15c's. The learn function doesn't seem to work very well with the 15c. For me all of the network bindings I had in Lonspec were lost. I'll never use Lonspec for an xl-15c w/jace again.
    Last edited by rad1; 10-29-2008 at 08:11 PM. Reason: spelling
    RealEyes
    Realize
    RealLies!




Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event