Results 1 to 2 of 2
  1. 10-12-2008, 07:50 AM #1
    chill bill
    chill bill is offline Professional Member
    Join Date
    Dec 2005
    Location
    Melbourne, Australia
    Posts
    91

    Carrier Flowtronic connection

    Hi Everyone,
    Having a slight problem with the carrier flowtronic program. Can you run the program off a cd rom, or do I need to install or save it onto the computer before using. Tried to connect to chiller, using USB to 9 pin lead, through the carrier converter RS 232 to RS 485, then connection lead into chiller comm1 port. All wiring is as stated, but cannot pick up chiller information. Problem reads; The system cannot open comm1 port requested by the application.
    Does anyone know something about this problem? If so, your input would be greatly appreciated. Cheers CHILL BILL.
    Last edited by chill bill; 10-12-2008 at 07:56 AM.
    Reply With Quote Reply With Quote
  2. 10-12-2008, 09:38 AM #2
    Dallas Duster
    Dallas Duster is online now Professional Member*
    Join Date
    Jan 2008
    Location
    Dallas ,Texas
    Posts
    3,506
    Sounds like your computer is using comm port 1 already. That`s why when you start that program is try`s to use comm port 1 and basically means it`s busy. And you should be able to run it without saving it.
    UA 100

    It takes three people to do anything around here. Two do the work, one explains to the crowd of people who showed up when they seen smoke and flames.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules