has anybody been able to do a direct connect to an e-2 with 3-4 more controllers with patch network instead of echelon and back-up the whole store from the bx each rx has their own i.p there is a hub but it give me a no port error if i use cross-over or cat-5e cable and if i use usb to 9 pin it gives me an error but i can go to each controller and back-it up but they dont drop the other rx's?any ideas?
Have you ever connected to an E2 before with a "cat5"? (crossover)
Originally Posted by gatorfan9606
You have to set the IP on your laptop to a close I P
RX#1 IP 22.214.171.124
RX#2 IP 126.96.36.199
RX#3 IP 188.8.131.52
laptop IP 2.2.210
Default gateway on E2=184.108.40.206 or220.127.116.11(I think I've even left this blank
Edit communications in ultrasite to the store to one of the controller IPs like 18.104.22.168. should connect. If connecting to the router.
Whichever RX/BX set ultrasite IP to that controller connecting to.
Last edited by NedFlanders; 07-17-2008 at 08:50 PM.
lap top IP only needs to be one digit ahead of the bx.just go up one on the
yes i have connected before.but each rx is not echelon together i know about the last digit been off by one and the l.a.n but if you go through the bx you only get the bx thier using cat 5e to each rx so when you unhook the cat5 of the bx to do an tcp/ip connection you stop comm between other controllers so you dont drop the other rx's?