Results 1 to 2 of 2
  1. #1
    Join Date
    Jul 2009
    Location
    iowa
    Posts
    16

    0-10 vdc actuator with a 4-20 ma output

    Hey everyone I just replaced a bad valve and actuator with a new one and purchased a 0-10 vdc actuator (Siemens ssb61u) and planned on changing the output on the computer to 0-10 vdc but found out my w7760a controller is preset with a 4-20 ma signal i cant change. Siemens don't make a 4-20 ma actuator to fit my powermite 599 valve. Is there a way to change the signal with a resistor or another actuator that will work

  2. #2
    Join Date
    Jan 2008
    Location
    Dallas ,Texas
    Posts
    3,668
    How`s about a 500 ohm resistor?
    UA 100

    It takes three people to do anything around here. Two do the work, one explains to the crowd of people who showed up when they seen smoke and flames.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event