Results 1 to 4 of 4
Thread: Traulsen Reverse Engineering
-
02-29-2008, 10:42 PM #1
Professional Member
- Join Date
- Mar 2007
- Location
- wedged in freezer shelf
- Posts
- 5,165
Traulsen Reverse Engineering
Is Traulsen going in the wrong direction with some new stuff I've been seeing?
Did the old Hobart guys get their hands in there and start making changes?
Anyone change a condenser fan motor yet on one that uses three mounting screws?
Can anyone think of a reason for this besides using one less screw?
It's not like a Q1 yet but it's getting there
If You Can Dodge A Wrench You Can Dodge A Ball
-
03-01-2008, 09:07 AM #2
Professional Member*
- Join Date
- Mar 2005
- Location
- burlington county n.j.
- Posts
- 9,342
lost all hope for traulsen when they came up with the pos digi-traul system......
-
03-01-2008, 01:25 PM #3
Professional Member
- Join Date
- Mar 2007
- Location
- wedged in freezer shelf
- Posts
- 5,165
After the umteenth revision of the intelatraul I kind of like it now
It seems like a waist of a control on the cheaper cabinets in the line though
It is the little simple stuff that is beginning to erk me and make service a chore $$$
Gotta make sure the drill is charged before I go out on one with all the screws now
If You Can Dodge A Wrench You Can Dodge A Ball
-
03-01-2008, 08:00 PM #4
Professional Member
- Join Date
- Apr 2005
- Location
- AZ
- Posts
- 180
I've replaced one of those cond fans, good times i tell ya. Also had one doa, had to replace the txv which was easy enough but getting to that drier to change it what a joke.
Reply With Quote
