Results 1 to 3 of 3
  1. #1
    Join Date
    Nov 2007
    Posts
    1

    Rheem quits power

    I have a Rheem Criterion2,installed in my basement,just had it "cleaned",inspected yeasturday,everything was fine,they could not find any issue and told me it was pretty clean anyway...,so,today,I hear the furnace starting,flame then blower,and suddenly quits,dead after 5-10 seconds after blower started.I checked the fuse,fine,raised temp on thermostat,will not start,dead.I fliped the power switch next to the furnace off,then on, and it started and ran fine,for now...what would it make go dead? and not blow the fuse if overloaded...

  2. #2
    Join Date
    Aug 2006
    Posts
    112
    circuit boad - plug connector - ground wire connection - flame rod - pressure port - bad system ground - pressure switch - tstat relay - or mabey just the fact that you got rheem-duhhhhhhhhhhhh!!!!!

  3. #3
    Join Date
    Mar 2004
    Location
    Illinois
    Posts
    6,959
    You need to call your service company back to re-visit the furnace.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine