Does anyone have a copy of CIS software to access TEC controller subpoints? I use datamate but find it painfully slow in updating subpoint values. I recall that CIS gives you more real time response to changes. I believe there is a newer version that has a windows appearance.
Thanks for the consideration.
Siemens came out with WinCIS but I believe it was for their use only. When I used it (over a year ago) there were still bugs, such as locking up the TEC.
what is your email
I could send a copy
Thanks so much.....the e-mail is:
Last edited by jrbenny; 01-31-2008 at 08:05 AM.
Funny post timing, I'm having the opposite problem.
I have CIS on an older laptop with windows 95 and recently upgraded to a newer laptop with XP.
Now i'm trying to get ahold of datamate.
Should we swap?
Edited by powerhead on more than one occasion
I'll send you a copy in the morning when I get in to work.
need CIS running on XP
I just install the TEC Unit Vent Controller P/N 540-509, unfortunately the TEC can't communicate with BMS
Here data collected from the field.
The TEC on the field configured as follows:
DO8 as START/STOP
DI2 as AIRFLOW STATUS
DI4 terminal no. 21-22 JUMPERED
AO2 as MOTORIZED VALVE MOTOR
With this configuration, which application used?
How can I program the TEC?
Software to monitoring the TEC is INSIGHT ver 3.1
On the monitor displayed point details as follows:
Point Name : CA1L
Point Type : LD0
Descriptor : C AHU1 LT LG
Can I program the TEC using INSIGHT?
But I can't find any menu used for programming
DO : 00511150
Please send me copy of software to program the TEC
Do this physical address indicate the address that should be programmed?
Hoping you help, thank you
Having trouble accessing TEC using hyperterminal. Insight due for update from Siemens to 3.11. Not getting handshake from TEC.
Originally Posted by gkstriper
Have window xp. Need access to TEC.
Will be upgrading to insight 3.11 with datamate advance once our IT dept gets us a new server. Need to access a TEC to set up the parameters and have not been able to get a handshake using hyperterminal.
Could you please send me a copy also?
Originally Posted by exwtk
Check my profile for my email address.
If Datamate is available I would appreciate a copy also.
My profie includes my email address.
does anyone have a copy of datamate???? or mind to send it...
Can I get wincis too? As i understand it there is a newer end user gui based software out. Do you know what it is?