Apogee Point ?
Results 1 to 4 of 4

Thread: Apogee Point ?

  1. #1
    Join Date
    Aug 2008
    Posts
    500

    Apogee Point ?

    i am trying to use commander to override a point from 5 psi to 1 psi but system says it is not allowed. why is this?

  2. #2
    The programmer may have that range locked out. Contact your apogee tech to find out why your limited

    Sent from my SAMSUNG-SGH-I747 using Tapatalk

  3. #3
    Join Date
    Aug 2013
    Location
    Halifax, Nova Scotia, Canada
    Posts
    32
    When a point is created in the system, a range is defined and a slope and intercept is calculated. Sounds like yours was created with a range of 5psi to ?? (13psi?). To change the range you have to edit the point, and define the new range which calculates the new slope and intercept.

  4. #4
    Join Date
    Aug 2008
    Posts
    500
    Quote Originally Posted by Gord Savage View Post
    When a point is created in the system, a range is defined and a slope and intercept is calculated. Sounds like yours was created with a range of 5psi to ?? (13psi?). To change the range you have to edit the point, and define the new range which calculates the new slope and intercept.
    so if I ask to go beyond the range insight will not allow?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event