Results 1 to 2 of 2
  1. #1
    Join Date
    Oct 2003
    Location
    Pacifica, California
    Posts
    87

    YDTJ-CB Manufacturing Defect.

    Gents, when you put them on the floor, and you pull all the plugs out to blow out the oil passages, do yourselves a favor and check to the the oil passages are actually drilled out entirely.
    Just overhauled a CB, only to find out after a quick failure that the oil passage feeding the front pinion bearing stopped short of reaching the supply galley by .178", verified by my good friends at York.
    Just a heads up to hopefully save you good people the headaches.
    Go the extra mile, it's shorter than you think. UA in the Bay

  2. #2
    Join Date
    Oct 2003
    Location
    tidewater, va
    Posts
    2,081
    thanks for the tip

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event