Results 1 to 3 of 3

Thread: York Yt

  1. 03-11-2007, 08:52 PM #1
    hvacr's Avatar
    hvacr
    hvacr is offline Professional Member
    Join Date
    Dec 2005
    Location
    North America
    Posts
    299
    Post Likes

    York Yt

    I have to repalec shaft seal and high speed thrust cover gasket, I have done it before but everytime it has been a complete tear down do you guys recommend tearing off the Motor or can it be done thru the man holes
    Thanks
    Quick reply to this message Reply   Reply With Quote Reply With Quote
  3. 03-11-2007, 09:12 PM #2
    absrbrtek's Avatar
    absrbrtek
    absrbrtek is offline Professional Member
    Join Date
    Aug 2000
    Location
    Under my tree
    Posts
    5,133
    Post Likes
    Thru the D ring inspection covers.
    Quick reply to this message Reply   Reply With Quote Reply With Quote
  4. 03-12-2007, 10:12 PM #3
    all around joe
    all around joe is offline Regular Guest
    Join Date
    Jun 2006
    Posts
    8
    Post Likes
    pull the motor coupling and low speed shaft one get I belive it is 1/4 threaded rod and install in the seal try to pull out if that wont work need to use a center puller wth the 1/4 rod PROTECT THE SHAFT this how ive done plenty of them also make sure the pressure is set properly when you start up 1.5 to 3 lbs good luck
    Quick reply to this message Reply   Reply With Quote Reply With Quote

Quick Reply Quick Reply

Register Now

Please enter the name by which you would like to log-in and be known on this site.

Please enter a password for your user account. Note that passwords are case-sensitive.

Please enter a valid email address for yourself.

Log-in

« Previous Thread | Next Thread »

Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules