Network 8000 software

**Control Man** · 12-07-2010, 05:07 PM

Did you swap over the SECURITY key for your copy of SIGNAL from the old computer ?

**control$** · 12-07-2010, 06:14 PM

"Did you swap over the SECURITY key for your copy of SIGNAL from the old computer ? "

I've found removing the text file is easier.

**Control Man** · 12-07-2010, 09:06 PM

Good for you

**scarletspider** · 12-08-2010, 11:52 AM

ok found some bulletin info , it was a cable from printer that was conflicting system, have it all up now. is there any "newer" software - front end- that would run this gcm 8000 system or is signal it for this older product?. also if the costumer wanted to replace this system with something newer, what are my options so that it stays open for us to work on and service, we not anybodys authorized dealer or factory trained representative...and also retain as much of the existing hardware/controllers as possible.

**berg2666** · 01-08-2011, 01:07 AM

Originally Posted by HVAC Teacher

I have them - do you need them?

You have XPSI, i am going to hit you up on email.

**berg2666** · 01-08-2011, 01:16 AM

Originally Posted by Destronger

i sent you the troubleshooting guide and the mz2 programming guide... hope that helps

i have xPSI... i don't know if i can distribute it though?

Me too me too for the manuals

**kevinbrock** · 01-08-2011, 01:48 PM

need your email to send the manual

**berg2666** · 01-08-2011, 06:48 PM

Originally Posted by kevinbrock

need your email to send the manual

I will email it to you ...... I thought it was in my profile after I send you the email from me i will go check my profile for accuracy.. Thanks

**Cuziwanano** · 06-22-2011, 12:31 AM

to a DOS based computer.
Have XPSI, MZ but no documentation. Any manuals for trouble shooting, programming BC would be awesome. Shows all site as "Empty" and "Disconnected".

Any help would be really appreciated.