Results 1 to 6 of 6
  1. #1
    Join Date
    Feb 2010
    Location
    In a boiler room
    Posts
    6,914

    Refrigerant hoses

    What is the latest and greatest in hoses? My YJ ball valve hoses need replacing again, the shaft for the ball valve leaks after only 6 months

    Thinking of trying some low loss hoses.

    Stick with YJ or is there something better out there?

  2. #2
    Join Date
    Feb 2010
    Location
    In a boiler room
    Posts
    6,914
    Anyone have the JB Kobra low loss hoses? They look great and are a bit cheaper than YJ

  3. #3
    Join Date
    Sep 2007
    Location
    NH
    Posts
    1,109
    Quote Originally Posted by chuckcrj View Post
    Anyone have the JB Kobra low loss hoses? They look great and are a bit cheaper than YJ
    Had em for about 3 months, so far so good.
    Have been using the NRP low loss hoses and they are good too. I would stay away from the yellow jacket ones they are to big to use in tight spots. And leak to much.

    The only little problem I've had with the JB hoses are that they let a little more refer out than the NRP hosesout when screwing the hose on.. Almost like the depressed is further out. Which may be good for certain types of valve stems, like newer carrier units. Which I've had trouble with the NRP hoses depressing the valve stem enough.

  4. #4
    Join Date
    Sep 2008
    Location
    Western PA
    Posts
    24,946
    I've been using a set of NRP ball valve hoses for about a year, now.

    I've replaced seals a few times, but don't have any complaints about the hoses or valves.

    I dislike the low-loss type hose fittings whether NRP or YJ...

  5. #5
    Join Date
    May 2004
    Location
    Salt Lake City/Tooele
    Posts
    2,160
    Have my own made for a fraction of the cost. 6000 psi burst, stainless steel braided, rated for 28 microns vac. Talk with your local hose and fittings supplier. Parker brand 919B series hose and QC fittings. Key is to find a Parker representative with the fitting crimp machines on site, or you are paying a whole bunch more and might not be worth your while. I have 1/4 3/8 and 1/2 hoses in 1 ft, 3t and 6ft lengths for all flavors of our trade.

    Just what I have done.

  6. #6
    Join Date
    Feb 2010
    Location
    In a boiler room
    Posts
    6,914
    Quote Originally Posted by slctech View Post
    Have my own made for a fraction of the cost. 6000 psi burst, stainless steel braided, rated for 28 microns vac. Talk with your local hose and fittings supplier. Parker brand 919B series hose and QC fittings. Key is to find a Parker representative with the fitting crimp machines on site, or you are paying a whole bunch more and might not be worth your while. I have 1/4 3/8 and 1/2 hoses in 1 ft, 3t and 6ft lengths for all flavors of our trade.

    Just what I have done.
    I was thinking about that but I don't have a hose supplier anywhere close.

    I guess I could call NRP and have them custom made...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event