Supco M500 megger
To call this toy a Megger y is a joke. Not when you consider a true megger (Crank handle) puts out so much voltage it you could read microscopic faults in the winding insulation.
A certain resistance value would advise of moisture in system and a tech could perform a remedial procedure to head off comp damage.
This device generates a whooping 500vdc.
Just enough to find grounds, True megger?
What do you think?
I have one. I also have the Megger 420. Megger is actually a brand name. The Megger 420 can perform PI and DAR tests and actually give you results. Some other meters say they do the tests but are unable to give the results.
Originally Posted by hvac5646
I only use the Supco as a sales aid because it says "bad" and "caution" etc. I get a kick out of the term bad, I refuse to use the term. But I explain it to the homeowner. The results are similar for spot checks between the two actually. I think 500v is adequate for 240v systems as I recall.
Tell Colin Kaepernick you support his brave stance for racial justice
Can't wait to see who is the first to say in 2020 we need to nominate a true conservative.
“I’ve said if Ivanka weren’t my daughter, perhaps I’d be dating her.” Donald Trump
"I know words, I have the best words" Donald Trump
"I have the world's greatest memory and everybody knows that" When asked about the comment he responded "I don't know. Did I use that expression?" Donald Trump
"I know more about ISIS than the generals do. Believe me." Donald Trump
I guess it revolves around what your budget is. I personally have an Extech 38---something Analog Megohmeter. It runs around $200 and does what I need it to do on an everyday basis. We have a Fluke 1550 that we use for the expensive equipment. That meg meter runs $4K+ so, I am not about to let it ride around in the back of someone's van. It stays safely at the shop until it is needed. So it only comes out when we are trying to troubleshoot a large chiller or very large motor, etc... A meg meter is to be used as one tool in the diagnosis, not a be all end all. I like the idea that Jim mentioned of using the idiot light model to show the owner or building rep that something has failed or is going to fail.