316 SS AHU and duct

[Li5iD]

After providing measurements for my foreman he only left us 8 inches of space to slide in a transition, this job should have gone to the wall of fame, unfortunately with that aggressive of a transition I'm truly ashamed of this.

[mark beiser]

Why not take the last section of duct out, or cut part of it off, and do it right?

[Li5iD]

That's what I suggested, cut back one length and put in a proper transition, Forman didn't want to bring in a mig for us and said he didn't want to waste the duct, lol pretty sure he just doesn't want to look bad. I can't see the engineer liking what he see's when he comes to inspect it though. The job is 27 hours from the shop so the foreman knew he only had one shot at it. Still it's not hard when your givin all the measuments.

[cehs]

Lack of communication, I don't think so.
This is just Foreman screwing up and didn't want the HIGHER ups to find out....
.