Originally Posted by GT Jets
Great way to see it.
Since you mentioned ohm's law, remember these things:
1) Ohm's law is a resistive circuit law.
2) Motors create counter EMF, which acts like a resistance to limit current, but it is NOT a resistance.
3) Motor calculations use Impedance (Z) in place of Resistance (R) and phase angle Theta (the value used is the Cosine of Theta) to account for the effects of inductive and capacitive reactance used in motor designs.
In this case, fans are the devices used to place a load on the motor in order to do useful work, so it is important to understand the circumstances of when the fan places a load on the motor, as JP motioned.
[Avatar photo from a Florida training accident. Everyone walked away.]
2 Tim 3:16-17
RSES CMS, HVAC Electrical Specialist
AOP Forum Rules:
As it pertains to motors (or solenoids), it needs something (a load) to induce a voltage into to counteract the current flow in the windings. Without this, you have a direct short across the windings. A plunger in the case of a solenoid, or the iron bars on the rotor of a motor. As the motor spins faster, the induced magnetism in the iron bars cut the magnetic field from the stator more frequently, thereby counteracting the current flow. Hence, high current at start up (the bars are not turning).
Solenoids and contractors will burn up if anything prevents the plunger from pulling in. On a related note, always put something in a solenoid if you have to remove the plunger, JUST IN CASE it gets energized while it is removed.
Something metal, like a nail or screwdriver
ohm's law is referring to electrical resistance, so it does not apply to the example you are using. Your example is dirty blower wheel (or restricted blower wheel, like bearing doesn't run smooth etc...), having such case, you have to use more WORK to move the wheel, which means the motor is working HARDER than usual, so the amperage goes up. You use the power equation in this case
Power (work done per unit of time) = Voltage * Current
Since voltage is constant, then power is directly proportional to current, so as power goes up (as more work is done), the current goes up.
A PSC motor on a radial fan will over-amp if it has no resistance (static pressure) to work against. Why is that?
Here is a little more on the subject. http://hvac-talk.com/vbb/showthread....1#post15675481
Originally Posted by air1
First: resistance to air flow Is Not electrical resistance.
Second: resistance to air flow only increases motor loading in the case of a positive displacement situation - which a blower motor typically is not. So a clogged blower wheel would Reduce motor loading - not increase it. You can prove this to yourself by blocking the supply or air while monitor the amp draw of the blower motor.
Originally Posted by HVAC_Austin
The conventional view serves to protect us from the painful job of thinking.