Vacuum rated valve core remover tool - Page 3
Page 3 of 3 FirstFirst 123
Results 27 to 30 of 30
  1. #27
    Quote Originally Posted by ClimateCntlJohn View Post
    Haha, i just ordered another Appion for myself and stumbled upon this thread. Ive been using a YJ that I've had for years and an Appion. The YJ I recently found leaks past the ball valve. So, appion gets my vote too.
    Appion isn't bad. But I like my C&Ds too. They don't leak.

  2. #28
    Join Date
    Jan 2009
    Location
    Salisbury, Maryland
    Posts
    135
    I honestly considered C & D but I could never find any literature about how well they performed under vacuum. Ill keep them in mind for next time since they are a little cheaper.

  3. #29
    Quote Originally Posted by ClimateCntlJohn View Post
    I honestly considered C & D but I could never find any literature about how well they performed under vacuum. Ill keep them in mind for next time since they are a little cheaper.
    C&Ds are good to 200 microns. But that's taking the mfg's word on it. They have not been tested by C&D, but I have no problem holding a 300micron vacuum with them.

  4. #30
    Join Date
    Jan 2009
    Location
    Salisbury, Maryland
    Posts
    135
    Sweet, good to know. Anyone have good experience with the Uniweld CRTs?

Page 3 of 3 FirstFirst 123

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event