Results 1 to 13 of 16
Thread: Homemade return
02-25-2013, 10:21 PM #1
No heat call today. Found this lovely return.
02-25-2013, 11:00 PM #2
At least he caulked it, lol.
02-26-2013, 03:23 AM #3
Nice!! No sheet metal cuts that way!!
03-03-2013, 12:55 PM #4
I would be more bothered by the furnace.
02-26-2013, 12:15 PM #5
I didn't know they made plenum rated OSB.
02-26-2013, 01:07 PM #6
02-26-2013, 01:17 PM #7
Looks like he found that furnace in the dumpster.Certified parts changer.
02-26-2013, 01:40 PM #8
02-27-2013, 12:36 PM #9
It's a return so what's wrong with it? If its sized rite it's fine. You never seen panned floor joists for return before?
02-27-2013, 11:24 PM #10
02-28-2013, 07:39 PM #11
That's better the what most diy'ers would do. I'm impressed" dirty filter??!!! Buts its only 2 years old"
03-01-2013, 12:06 AM #12
Is it bad that my furnace at home is sitting on an OSB platform? I am doing a change out in a couple weeks and during the process I was planning on sealing it from the inside. Its all original from 1993.The platform acts as the return plenum. Not nearly as bad as this one lol. 16'' flex duct from house goes straight into said plenum.
03-01-2013, 07:11 PM #13
Personally I have built plenums out of osb and 2x4's before. They were for twinned furnaces usually in a commercial building like a bank. As long as its sealed, it works fine. But that's just my experience." dirty filter??!!! Buts its only 2 years old"