Results 1 to 5 of 5
  1. #1
    Join Date
    Feb 2013
    Posts
    9

    Johnson FX-PCT Programming and Commissioning Tool software

    Can anybody answer this, I just downloaded a new FX-PCT programming and commissioning tool from Johnson controls. The very first page top left has the 'configure' and 'commission' tabs and the top right has the 'select system' and 'define hardware' tabs, for some reason the 'commission' tab is the only one that allows access in the program and commission only. I'm trying to configure a new controller and the 'configure', 'select system' and 'define hardware' tabs don't allow access.
    Anybody have the same problem with this?

  2. #2
    Join Date
    Nov 2005
    Location
    Shreveport, Louisiana
    Posts
    2,324
    You were sold the commisioning only version...
    UA Local 141

  3. #3
    Join Date
    Feb 2013
    Posts
    9
    i think your right!

    cheers

  4. #4
    Join Date
    Feb 2013
    Location
    North Carolina
    Posts
    40
    When you go to first install it you should have the option to choose the full version or the commissioning only version. Make sure you installed the full version.

  5. #5
    Join Date
    Feb 2013
    Posts
    9
    thanks! this works.....

    cheers

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event