I ran into a job that has McQuay heat pumps going to an older MIG (looks like a companion) which goes to an NCM350. There is also another network of McQuay heat pumps going to another MIG (looks like an N30) which goes to another NCM350. Id like to replace the NCMs with an FX60 im just not sure what to do with the MIGs. I was looking at some older posts from a few years ago so I dont know if there are other options now. Is there a driver for the mcquays? I think they are using the microtech boards. It looks like I need the VCT files for the MIGs if they were to stay. Anyone have any other options? TIA