I had to go to a job yesterday and look at a Honeywell SymmetrE system. It doesn't seem to be the most user friendly system, but I managed to get some of the issues fixed. One of the problems I am having is on one of the AHUs. The customer had everything on this particular unit in override. I released all of the overrides and noticed that when I clicked on each of the points from the graphics that the automatic read value appeared to be normal, but in the bottom left of the screen it was some very strange values. The graphics also showed these strange values on them. Like for instance it could show 80 degrees supply air temperature in the automatic field on the point, but in the bottom left of the point screen (where you can choose auto or manual) and the graphic it would just stay at 43 degrees. I even tried to switch it to manual at 80 degrees and the graphic would never change and eventually the point would revert back to 43 degrees in the bottom left of the points screen in the manual or automatic mode. I was told there are a lot of different layers in a SymmetrE system. What kind of things can I do to troubleshoot this problem? Each AHU has a XL50 controller on it that is assigned to a XL5000 Point Server. Thanks for any help on this!