I have just recently started a new job where the BAS system is Seimens Apogee, using the Insight work station. As of yet I am unfamiliar with this system as I am with others. I have been given the task of installing several hundred discharge air sensors on heat pumps which are using a TEC module at each unit. My question is how do I now get these sensors online to my front end and update my graphics to reflect this. On previos systems I have used it was simply a matter of assigning the analog point and up updating the system, then adding the necessary graphic using their graphic suite( ie RC studio). Any help would be appreciated. I believe the Insight version we are using is 3.11.