Results 1 to 3 of 3
  1. #1
    Join Date
    Jan 2013
    Post Likes

    Lennox Pulse 21 Question

    The ignition control module was just replace but the furnace still doesnt run, it just continually cycles and the fan continually runs.

    Also the air flapper valve was cleaned.

    Could this be a problem with the spark plug or heat sensor?

    Thank you

  2. #2
    Join Date
    Mar 2004
    Post Likes
    The Lennox Pulse is a unique unit that requires a skilled mechanic.

    It should also have a professional perform a heat exchanger test on it to make sure the integrity of the heat exchanger is good.

    It could be anything but nothing that you can fix without the knowledge to do so.

  3. #3
    Join Date
    Mar 2005
    burlington county n.j.
    Post Likes
    spark plug only fires for about 7 seconds at beginning of cycle and flame sensor only proves it is firing,
    normally neither one of these parts will cause your problem.
    find someone trained on the pulse and have them check it out.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.