Volume Damper Design
first, i have spent some time trying to figure out which forum to post my question at, and i hope this is correct. Please remove it in case i was wrong. i hate breaking the rules
Well, i'm working on a project of manufacturing an in-house volume control dampers, i'm working on the design now and it's almost done.
However, i'm still stuck at some points without any answers:
1- how to decide proper number of blades ? (in case of having diffrent widths, e.g.: either 5 blades of 4" or 4 blades of 5")
2- how to decide where to place the extended shaft or the manual handle, top balde or center or bottom ? based on what.
Thanx in advanced guys.
You should probably go to an engineering forum. Try http://www.eng-tips.com I'd go the route of the least blades in the airflow and for the handle mounting location, I have seen them positioned in the middle and top or bottom. I doesn't really make a difference to me
Thanx Vinster, i'll give it a shot.
Another option is www.physicsforums.com. They have a Mechanical Engineering section in there.
Simpler is better. Do use all a favor and keep in the back of your mind, the poor technician that will one day have to replace the actuator or the connecting rod.
cool website , meplumber !