Bad liquid service valve

[myott]

Went out today to do a simple coil-pull-and -clean and low and behold a huge problem. Went to do a pump down and shut the liquid line service valve and guess what? It would not shut down. I took and pressed down on it to get the threads started but that did not work. Duhhhhhhhh......

Had to explain to the customer that I now need to replace service valve as well as the coil clean. Lucky he understood and I grabbed the recover tank and recovery machine to reclaim the R22. Cut coil out and cleaned with my coil gun, man I love that thing.

Reinstalled coil and added new heat pump dryer while at it. Cut service valve out and installed new one. Charged to proper superheat using my Amp-probe to take WB readings and plugged in the super heat reading to SMAN3 to dial it in.

I am thinking the installer must have cooked the valve and when he opened the valve on start up , front seated to valve to much. What do you guys think?

Sent from my iPad using Tapatalk HD

[gravity]

Sounds practical.

[VTP99]

Cut coil out and cleaned with my coil gun, man I love that thing.

Do you always remove the coil to clean ?

I am thinking the installer must have cooked the valve and when he opened the valve on start up , front seated to valve to much. What do you guys think?

Sent from my iPad using Tapatalk HD

Did you mean to say back seated the valve to much ?

[timjimbob]

If Lennox, these are one shot valves and will not close.

[t527ed]

If Lennox, these are one shot valves and will not close.

when they did use them it was only on the suction line, they have not been used in quite a few years though.

[myott]

Yes, back seated valve.

[myott]

If Lennox, these are one shot valves and will not close.

It was a Carrier

[timjimbob]

myott- get a pinchoff tool or two. You can stop the refrigerant in copper tube like it was a valve and open it later.

Great for adding a LL filter without having to pump down system, or if your service valve is broke.

[SkullMonkey]

myott- get a pinchoff tool or two. You can stop the refrigerant in copper tube like it was a valve and open it later.

Great for adding a LL filter without having to pump down system, or if your service valve is broke.

Never thought of this. Do you open the tubing using a flaring block?

[timjimbob]

Same tool .does both

[SkullMonkey]

Thanks, that will come in handy.

[Twoholing]

**** happens and valves fail to hold all the time, no need to automatically blame the installer or a person.. That effing valve was probably made in China anyway.

[hvac5646]

Valves aren't what they used to be. I heat sink the valves with extra rags...makes brazing a little tougher, but at least I don't cook any more cheap Chinese valves.

I'd hate to be the guy using a Turbo Torch these day...you have to use them full open and you can't adjust the flame size. Makes for any easy overheat situation.

I know few guys who can use a Turbo with out over heating line set and valves.