Interesting Current behaviour

[jayguy]

Don't use a electronic flash on the camera to take a picture of a solid state starter. Some drives will shut down due to the energy flash. I don't know why but i have seen it happen.

what brand? i want to try that!

[Nuclrchiller]

Now thats funny....LOL

Reading "One" leg on a six-lead motor should give you a reading of 58% of the actual motor current. "NOT" 50%....I digress in stating the reasoning behind this.

Not sure why that's funny, Richard, but it wouldn't be the first time a joke has gone over my head. Even one of my own.... I was concerned that the OP would not be successful in indicating an actual location as a location on the drawing. I hope that statement makes sense.

[mayank]

Hey guys why you all diverting from the topic.I am here to get a solution but you started your convesation.I have alreday uploded the pic of the concerned part.

[Nuclrchiller]

It is very important to measure current at the right locations. You want to be sure that you are comparing the current on the 3 separate phases to each other, or the current on the 6 motor leads to each other. You may have been comparing the current on 1 of the phases with the current on 1 of the motor leads. They will not match. See RichardL's statement above.