The technician who looked at my Carrier 58CVA furance last week (or end of the previous) seems to think it doesn't matter than my Inducer Fan blade appears a little "wobbly" I would like other opinions. This furance was installed at the beginning of January of this year.

This is a video of it spinning with the furnace off and after I spun it by hand. If you stare at the outer edge, at, say, the lower left side, you'll notice it appears "wobbly". It does spin very freely and even seems to spin a little on it's own at the slightest air current (or whatever). (Better to watch in HD if possible)

Does this fan look normal to you, or does it look out of balance, and therefore likely noisier than normal when it's running during the first 35 seconds of start-up? Let me know. Thanks.