Results 1 to 6 of 6
Thread: EMC End Bells ?
-
01-05-2013, 08:00 AM #1
Professional Member*
- Join Date
- Sep 2002
- Posts
- 32
EMC End Bells ?
I have found several ECM evaporator motors that have bad end bells recently. They are out or warranty and I was wondering if anyone has had any luck trying to rebuild these things? Usually it is a blown thermister or capactor and it does not look like are difficult repair.
-
01-05-2013, 08:45 AM #2
Professional Member*
- Join Date
- Feb 2010
- Location
- Calgary, Alberta
- Posts
- 755
Do a forum search, there's a repair thread with pics I believe.
-
01-05-2013, 09:09 PM #3
Professional Member
- Join Date
- Jan 2013
- Location
- California
- Posts
- 81
Power surges are what kill the bell ends. Install a surge protector in the unit and you'll won't have to worry about it going bad anymore.
-
01-05-2013, 09:17 PM #4
Professional Member*
- Join Date
- Dec 2002
- Location
- Arizona
- Posts
- 3,760
Other than high SP conditions.
Originally Posted by Strkout499
Make your expertise uniquely valuable.
Make your influence uniquely far-reaching.
-
01-05-2013, 09:45 PM #5
Professional Member
- Join Date
- Jan 2013
- Location
- California
- Posts
- 81
haha good point, should have thought of that one. Originally Posted by jimj
-
01-06-2013, 02:24 PM #6
Professional Member*
- Join Date
- Jul 2007
- Location
- Tulsa, OK
- Posts
- 846
Get much higher than .75"wc and the motor may crap on you within 2 yrs, .85 to .90 and it will within a year most likely because client will let the filter cake and then your going over 1.25"wc.
Reply With Quote
