Trane heat exchangers

[2141]

Has anyone else had an issue with trane heat exchangers? We are coming across about five a day. These furnaces are on average 3 years old and up.

[barriefurnacerepair]

Has anyone else had an issue with trane heat exchangers? We are coming across about five a day. These furnaces are on average 3 years old and up.

Where is the failure on the heat exchanger? What's your altitude?

[jpdc]

Yes I have. Their all cracking at the collector box. If you notice rust on the screws at the bottom then its cracked.

[2141]

Where is the failure on the heat exchanger? What's your altitude?

The secondarys crack easily seen behind the transition receptacle for the inducer but those are not the cracks I'm talking about. the cracks I was mainly referring to are underneath where the flame enters, on the left side of each chamber, off the top of the crimp. I think the altitude is 2000

[barriefurnacerepair]

The secondarys crack easily seen behind the transition receptacle for the inducer but those are not the cracks I'm talking about. the cracks I was mainly referring to are underneath where the flame enters, on the left side of each chamber, off the top of the crimp. I think the altitude is 2000

Altitude will make a difference on a hotspot. The code where I live [4.22.1] in Ontario references CSA/CGA 2.17 and states "...it shall be adjusted to the high-altitude rating shown on the nameplate when installed at elevations between 2000ft and 4500ft above sea level." This is quoted from CSA-B149.1-10.

The furnace should be derated on install. There should be a manifold pressure given on the nameplate for that elevation. Beyond 4500ft, it is 4% for every 1000ft in elevation....a way to verify derating is to clock the meter. 1 cu.ft = 1000BTU (roughly) as you may know.

HVAC-Talk has a thread referencing derating....
http://hvac-talk.com/vbb/showthread.php?75461-Question-about-derating-gas-furnace-for-altitude

[barriefurnacerepair]

Hey mod....where's the love? Make me a pro member already

[Foehammer]

Yeah problems with Tranes of all sizes, crappy material used to make the exchanger.

[2141]

Yeah problems with Tranes of all sizes, crappy material used to make the exchanger.

I'm glad to hear we aren't the only ones. As you probably know it is not a fun situation telling a customer that their 3yr old furnace is unsafe.

[Joehvac25]

This is scary, we have been a trane dealer around 3 years. Is there a recall or anything?

[2141]

This is scary, we have been a trane dealer around 3 years. Is there a recall or anything?

There is currently no recall. We have hounded trane for months and the do not admit there is a problem with their product. The bad part is the customers that decided to repair the furnace are replacing the heat exchangers with the same one that failed EARLY!

[Joehvac25]

Wow that's bad, the most expensive equipment on the market is bad. Is it all HXs or does is seem to be a certain model?

[Joehvac25]

On a pm today, this was installed a year ago, inducer sprung a leak.

[chuckcrj]

On a pm today, this was installed a year ago, inducer sprung a leak.

That furnace also has a cracked secondary